- Questions
- Stock Scanners
Votes
Answers
Views
Question
0
votes
1
answer
67
views
asked 5 years ago by Jocelyn Ducheine
Category:
Stock Scanners
Hi, First thank you for your very informative videos. I would like your help in creating a scan for stocks within 1 to 10% below their 52-week high. And a separate but similar scan for stocks within 5 to 10% above their 52-week Low. Thank you.
0
votes
1
answer
67
views
asked 2 years ago by Sabrina Leigh
Category:
Stock Scanners
Hi Pete, I always have trouble with writing this out in the Wizard. I would like to be able to scan for a 6 hour cross in the SlowStochastic. Here is my attempt, though it will not take it. My_Slow_Stoch()."SlowK" crosses above StochasticSlow()."Slow...
0
votes
1
answer
67
views
asked 5 months ago by StockedUp University
Category:
Stock Scanners
Hey Pete! I am running a scan and one of the parameters is for stocks that have twice or greater the amount of volume today than average. The problem is that let's say the scan is run 10 minutes after open, basically no stocks will get returned becau...
1
vote
1
answer
66
views
asked 4 years ago by Leo Ortega
Category:
Stock Scanners
Hello there Mr. Hahn, I have another very simple request for you. I already found the code to scan for inside bars on your site. What I would like next would be to scan for stocks that close in the upper 40% or lower 40% of the previous bars' range a...
0
votes
1
answer
66
views
asked 4 years ago by Fernand Prince
Category:
Stock Scanners
Hello, can you help ? All time high stock in daily chart within 2year for the last 2 month.
0
votes
1
answer
65
views
asked 6 years ago by A. D. Whitsett
Category:
Stock Scanners
Good morning Pete. Your forums and services has been a wealth of information. Thank you for that. What I am reaching out to you about today is the scan results not returned as expected. The “Premarket” scans populates after the market open, the “Perc...
0
votes
1
answer
65
views
asked 4 years ago by Eric Hughes
Category:
Stock Scanners
Hello again Pete, I have a question regarding a simple scan. Im trying to filter for an uptrend by stating different Sma and vwap be higher than they were X amount of bars ago. vwap>vwap [x]... and so forth with a 9 sma and 20 sma, and vwap.....
0
votes
1
answer
64
views
asked 4 years ago by Cole Walker
Category:
Stock Scanners
Hey Pete, I'm trying to figure out the code that would pull a stock when X volume occurs twice within 10 bars. So for example, stock ABC is pulled when its volume spikes above 10,000 on two separate bars but within 10 bars of each other. I appreciate...
0
votes
1
answer
64
views
asked 3 years ago by Tuan Pham
Category:
Stock Scanners
Hi Pete, I'm looking for a scan that gives the total value based on parameters of the daily RSI(14) + Slow Stochastics(14). Example: Scan for a total of less than 50 between the two. Thanks again!
1
vote
1
answer
64
views
asked 3 years ago by randomemoji :3
Category:
Stock Scanners
Hi Pete, I'd like to scan for stocks where the 34ema is at least one ATR above the 55ema. Thank you!
